KACO Powador-proLOG - Manual (Page 5)

Page 6 Operating Instructions Powador-proLOG_EN
2 Safety Instructions
and Regulations
Standards and regulations
IEC 60364-7-712:2002:
Requirements for special installations or locations – Solar
photovoltaic (PV) power supply systems.
Technical rules
The installation must be suited to the on-site conditions and
comply with local regulations and technical rules.
Accident prevention regulations
– The monitoring system for photovoltaic systems may only
be connected by qualifi ed specialists.
– Cables must be disconnected from all power sources before
being connected to or disconnected from the system.
– Read the manual and familiarise yourself with the unit prior
to operation
– Damaged units must be removed from operation immedi-
ately and inspected by a qualifi ed specialist.
– The unit is to be opened by a qualifi ed specialist
only.
– The safety of the operator and the unit cannot be guaran-
teed if the operator does not adhere to the safety instruc-
tions.
The proper and safe operation of this unit requires proper
transportation, storage, assembly and installation, as well as
careful operation and maintenance.
Transportation
The Powador-proLOG is subjected to extensive testing and
inspections at our test facility. Only by doing so can we ensure
the high quality of our products. Our data loggers leave our
factory in proper electrical and mechanical condition. Special
packaging ensures that materials are not damaged during
transportation. However, damage may still occur during trans-
port. The shipping company is responsible in such cases.
Thoroughly inspect the data logger upon delivery. Immedi-
ately notify the responsible shipping company if you discover
any damage to the packaging which indicates that the data
logger may have been damaged or if you discover any visible
damage to the data logger.
If necessary, KACO new energy GmbH will assist you. Damage
reports must be received by the shipping company in writing
within six days following receipt of the goods.
When transporting the data logger, only the original packag-
ing is to be used, as this ensures safe transport.
S e c t i o n 2 · S a f e t y I n s t r u c t i o n s a n d R e g u l a t i o n s
DANGER
Danger due to lethal voltages.
Lethal voltages are present within the unit and on the
power supply lines. Therefore, only authorised electri-
cians may install and open the unit.
ATTENTION
Risk of damage due to improper modifi cations.
Do not attempt to open or modify the data logger.