Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 39)

2.2 Linear Servomotor Installation
2-17
2
Installation
 SGLTM-AY Magnetic Ways
SGLTM-AY magnetic way is delivered with the magnetic way yokes
attached to a base.
1.
Place the base to which the magnetic way yokes are attached in the
specific location in the machine.
2.
Firmly secure the base to the machine with bolts using the base
mounting bolt holes.
3.
Mount the moving coil. For details, refer to (2)Moving Coil Installation.
Note: This concludes the procedure if there is only one magnetic way.
4.
Place the second magnetic way in line with and at least 30 mm away
from the first magnetic way.
5.
Press the second magnetic way against the first magnetic way and
firmly secure it to the machine with bolts using the base mounting bolt
holes. The magnetic attraction will pull the magnetic ways together. Be
careful not to get your fingers caught between the magnetic ways.
6.
Use the same procedure to install the third and later magnetic ways as
you used for the second magnetic way.