Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 156)

5 Trial Operation (Checking Linear Servomotor Operation)
5.5.2 When Using an Absolute Linear Scale
5-20
 Using the Panel Operator
Step Display after operation Keys Operation
1
Press the MODE/SET Key to select the Utility
Function mode.
2 Press the UP or DOWN Key to select Fn080.
3
Press the DATA/SHIFT Key for
approximately one second. The display shown
on the left will appear.
4
Press the MODE/SET Key to start the polarity
detection.
5 –
When the polarity detection is complete, the
display shown on the left will appear.
The linear servomotor will be in servo OFF
status.
6
Press the DATA/SHIFT for approximately one
second. The display will return to Fn080.
7 Turn OFF the power to the SERVOPACk and then ON again to enable the setting.
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/
MODE/SET DATA/