Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 135)

4 Safety Function
4-6
2.
Slide the lock injector of the safety function’s jumper connector to the
SERVOPACK side to unlock and remove the safety function’s jumper
connector.
Note:The safety function’s jumper connector may be damaged if removed while the lock
is still on.
3.
Connect a safety function device to CN8.
Note:When not using the safety function, use the SERVOPACK with the safety function’s
jumper connector (JZSP-CVH05-E provided as an accessory) inserted in CN8. If
the SERVOPACK is used without the jumper connector inserted into CN8, no cur-
rent will flow to the servomotor and no force will be output. In this case, "Hbb" will
be displayed on the panel operator or the digital operator.
Lock injector Safety function’s
jumper connector
1. Slide the lock injector
to the SERVOPACK
side. Enlarged View
Remove the safety function’s jumper
connector while the lock injector is slid
to the SERVOPACK side. 2.