Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 111)

3.3 Main Circuit Wiring
3-27
3
Wiring and Connection
3.3.3 When Using the SERVOPACK with a Single-phase 200 V
Power Input
Some models of Σ-V series three-phase 200 V power input SERVOPACK can be
used also with a single-phase 200 V power supply.
The following models support single-phase 200 V power input.
SGDV-R70A, -R90A, -1R6A, -2R8A, -5R5A
When using the SERVOPACK with single-phase, 200 V power input, set parameter
Pn00B.2 to 1.
(1) Parameter Setting
 Single-phase Power Input Selection
Parameter Meaning
When
Enabled
Classifica
tion
Pn00B
n.0
[factory
setting]
Enables use of three-phase power sup-
ply for three-phase SERVOPACK.
After restart Setup
n.1
Enables use of single-phase power
supply for three-phase SERVOPACK.
WARNING
• If a single-phase 200 V is input to a single-phase 200 V power input supported
SERVOPACK without having changed the setting of Pn00B.2 to 1 (single-phase
power input), the main circuit cable open phase alarm (A.F10) will be detected.
• If a single-phase 200 V is input to the SERVOPACK models that do not support
single-phase power input, the main circuit cable open phase alarm (A.F10) will be
detected.
• When using a single-phase 200 V power supply, the SERVOPACK may not be
able to produce the same linear servomotor force-speed characteristics as using
a three-phase 200 V power input. Refer to the diagram of each motor force-speed
characteristics in Σ -V Series Product Catalog (No.: KAEPS80000042).