Yaskawa Sigma-5 User Manual: Setup for Linear Motors - Manual (Page 164)

5 Trial Operation (Checking Linear Servomotor Operation)
5.6.1 JOG Operation Using a Panel Operator
5-28
6
Press the UP Key to move the linear servo-
motor in the forward direction or press the
DOWN Key to move it in reverse. The lin-
ear servomotor will move at the speed set
in the parameter Pn383 while the key is
being pressed.
7
Press the MODE/SET Key. The linear
servomotor will be in servo OFF status.
Note:
The linear servomotor can be also in
servo OFF status by pressing the DATA/
SHIFT Key for approximately one sec-
ond.
8
Press the DATA/SHIFT Key for approxi-
mately one second.
"Fn002" is displayed again.
9
Press the MODE/SET Key to return to
the initial display (step 1).
(cont’d)
Step Display after operation Keys Operation
MODE/SET DATA/ Forward direction
Reverse direction
/ /
MODE/SET DATA/
/ /
MODE/SET DATA/
Alternate
display
MODE/SET DATA/