Yaskawa SI-EN3/V EtherNet/IP for V1000 Drive - Manual (Page 47)

11 Troubleshooting
YASKAWA ELECTRIC TOBP C730600 60A V1000 Option EtherNet/IP Installation Manual 47
■ Explicit Message Communications Errors
When there is a problem with a request message sent from the master in explicit
communications, the drive will return one of the following error codes.
Note: Refer to the MEMOBUS/Modbus Data Table in the Technical Manual for a list of monitor data
using the MEMOBUS/Modbus message area.
Error
Code
(hex)
Description Cause Possible Solution
08 Service not supported The service code is incorrect. Correct the service code.
09 Invalid attribute value The attribute is incorrect. Correct the attribute.
0C Object state conflict
Attempted to change an drive constant
that cannot be changed while the drive
is running.
Stop the drive.
0E Attribute not settable
Attempted to change a read-only
attribute. Correct the service code or
attribute setting.
13 Not enough data The data size is incorrect. Correct the data size.
14 Attribute not supported
Attempted to execute a service not
defined for the attribute. Correct the service code or
attribute setting.
15 Too much data The data size is incorrect. Correct the data size.
16 Object does not exist An unsupported object was specified.
Correct the class or instance
setting.
1F Vendor-specific error
Attempted to change a drive constant
that cannot be changed while the drive
is running.
Attempted to change a drive constant
to a value outside the setting range.
Stop the drive.
Specify a value within the
setting range.
20 Invalid parameter
Attempted to change to a data value
outside the setting range. Specify a data value within the
setting range.
EtherNet_IM_E_conditional.fm 47 ページ ２０１２年３月１６日 金曜日 午後６時５分