Yaskawa SI-EN3/V EtherNet/IP for V1000 Drive - Manual (Page 23)

5 Installation Procedure
YASKAWA ELECTRIC TOBP C730600 60A V1000 Option EtherNet/IP Installation Manual 23
7.
For models CIMR-V†BA0001F to BA0003F, 2A0001F to 2A0006F, loosen the
screws attaching the NEMA Type 1 conduit bracket to the drive to remove the
NEMA Type 1 conduit bracket.
Figure 10
Figure 10 Remove the NEMA Type 1 Conduit Bracket
8.
On NEMA Type 1 enclosure models (CIMR-V†BA0001F to BA0003F, 2A0001F to
2A0006F), the screw for the drive ground terminal also acts as one of the screws
that attaches the NEMA Type 1 conduit bracket to the drive. Reattach the NEMA
Type 1 conduit bracket according to Figure 11 and connect the drive-side of the
ground wire to the drive ground terminal.
Note: The four different ground wires packaged with the option connect the option to different drive
models. Select the proper ground wire depending on drive size. Refer to Table 7 on page 21 for
ground wire selection by drive model.
Figure 11
Figure 11 Reattach the NEMA Type 1 Conduit Bracket and
Connect the Ground Wire for models CIMR-V†BA0001F to
BA0003F, 2A0001F to 2A0006F
V1000
Ground terminal
Ground wire
Drive ground terminal/
NEMA Type 1 conduit
bracket screw
Ground wire
Drive-side
connector
Screw size:
M3.5 to M6
Option unit
connector
Screw size: M3
V1000
EtherNet_IM_E_conditional.fm 23 ページ ２０１２年３月２１日 水曜日 午後３時２分