Yaskawa APOGEE FLN P1 - Manual (Page 9)

3 Receiving
Please perform the following tasks upon receipt of the option:
• inspect the option for damage. Contact the shipper immediately if the option appears
damaged upon receipt
• verify receipt of the correct model by checking the model number printed on the name plate
of the option package
• contact your supplier if you have received the wrong model or the option does not function
properly.
u Option Package Contents
Description
Option PCB
PN: UTC00063o
Ground
Wire
Screws (M3) LED Label
Installation
Manual
–
NS MS
TX RX
MANUAL
Quantity 1 1 3 1 1
u Tools Required for Installation
• A Phillips screwdriver (M3 metric/#1 or #2 U.S. standard size) is required to install the
option and remove drive front covers. Screw sizes vary by drive capacity. Select a
screwdriver appropriate for the drive capacity.
• Diagonal cutting pliers. (required for some drive models)
• A small file or medium grit sandpaper. (required for some drive models)
• A straight-edge screwdriver (blade depth: 0.4 mm, width: 2.5 mm) is required to wire the
option terminal block.
Note: Tools required to prepare option networking cables for wiring are not listed in this manual.
3 Receiving
YASKAWA TOEP YAICOM 13 Metasys N2 & Apogee FLN P1 SI-J3 Installation & Technical Manual 9