Yaskawa APOGEE FLN P1 - Manual (Page 31)

Object
ID
Object Name Units Default Value
Yaskawa Drive
Parameter
AO 13 Motor Rated Current A Motor model dependent E2-01
AO 14 Jump Frequency 1 0.1 Hz 0.0 d3-01
AO 15 Jump Frequency 2 0.1 Hz 0.0 d3-02
AO 16 Jump Frequency 3 0.1 Hz 0.0 d3-03
AO 17 Jump Frequency Bandwidth 0.1 Hz 1.0 d3-04
AO 18 Number of Auto Restarts - 0 L5-01
AO 19 Operator Display Mode - 0 o1-03
AO 20 Power Loss Ride-Thru seconds Drive model dependent L2-02
AO 21 Cable Loss Timeout seconds 2.0 F6-77
AO 22 Cable Loss Speed 0.01 Hz 0.00 d1-04
AO 23 PI Integral Limit 0.1% 100.0 b5-04
AO 24 PI Upper Limit Value 0.1 100.0 b5-06
AO 25 PI Offset Adjustment 0.1 0.0 b5-07
AO 26 PI Primary Delay Time 0.01 0.00 b5-08
AO 27
PI Feedback Reference Missing
Detection Select
1 0 b5-12
AO 28
PI Feedback Reference Missing
Detection Level
1% 0 b5-13
AO 29
PI Feedback Reference Missing
Detection Time
0.1 s 1.0 b5-14
AO 30 Read Parameter Number - - -
AO 31 Write Parameter Number - - -
AO 32 Write Parameter Data - - -
n Metasys N2 Binary Input (BI) Summary
Table 12 Metasys N2 Binary Input Summary (SI-J3 to Metasys N2)
Object
ID
Object Name Default Off (0) State On (1) State
BI 1 Run/Stop Monitor 0 Stopped Running
BI 2 Forward/Reverse Monitor 0 Forward Reverse
BI 3 Drive Ready Monitor 0 Not Ready Ready
BI 4 Fault Monitor 0 Not Faulted Faulted
BI 5 Zero Speed 0 Not Zero Speed Zero Speed
BI 6 Speed Agree 0 Not Speed Agree Speed Agree
BI 7 Minor Fault 0 No Minor Fault Minor Fault
BI 8 Major Fault 0 No Major Fault Major Fault
BI 9
Drive Communication Error
Monitor
0 No Error Error
9 Metasys N2 Communications
YASKAWA TOEP YAICOM 13 Metasys N2 & Apogee FLN P1 SI-J3 Installation & Technical Manual 31