Yaskawa APOGEE FLN P1 - Manual (Page 12)

Name
Display
Operating Status Remarks
Color Status
RX
- OFF No data seen on the network The option is not physically connected to the
network or there is no network activity.
Green Flashing Data is seen on the network The option is connected to a network.
n Power-Up Diagnostics
An LED test is performed each time the drive is powered up. The initial boot sequence may
take several seconds. After the LEDs have completed the diagnostic LED sequence, the option
is successfully initialized. The LEDs then assume operational conditions as shown in
Table 3 .
Table 4 Power-Up Diagnostic LED Sequence
Sequence Time Module Status (MS) Network Status (NS) Tx Rx
1 Initial OFF OFF OFF OFF
2 0.25 seconds Green OFF OFF OFF
3 0.25 seconds Red OFF OFF OFF
4 0.25 seconds OFF Green OFF OFF
5 0.25 seconds OFF Red OFF OFF
6 0.25 seconds OFF OFF Green OFF
7 0.25 seconds OFF OFF OFF Green
8 Run Time Go to proper state Go to proper state
Go to
proper state
Go to
proper state
4 Option Components
12 YASKAWA TOEP YAICOM 13 Metasys N2 & Apogee FLN P1 SI-J3 Installation & Technical Manual