Yaskawa iQpump Micro Quick Start - Manual (Page 58)

i.6 Start-Up Programming and Operation
u Keys, Displays, and LEDs on the Standard LED Operator
5 1
11
12 13
8
15
14
16
10
2
3
AUTO OFF
HAND
4 6
7
9
Table i.16 Keys and Displays on the LED Operator
No. Display Name Function
1 Data Display Area Displays the frequency reference, parameter number, etc.
2 ESC Key Returns to the previous menu.
3 RESET Key
Moves the cursor to the right.
Resets the drive to clear a fault situation.
4 AUTO AUTO Key
Selects the source of Run command and frequency reference.
• Set the drive to AUTO mode.
• Run command input source depends on b1-02.
• Frequency reference input source depends on b1-01.
5 Up Arrow Key
Scrolls up to display the next item, selects parameter numbers, and increments setting
values.
6 Down Arrow Key
Scrolls down to display the previous item, selects parameter numbers, and decrements
setting values.
7 OFF OFF Key Follows the stopping method set in b1-03 to stop drive operation.
8 ENTER Key
• Enters parameter values and settings.
• Selects a menu item to move between displays.
9
HAND
HAND Key
The drive runs at a selectable frequency reference source as set by P5-01.
• Set the drive to HAND mode.
• When P5-03 is set to 1, HAND and AUTO mode can be switched while the drive is
running.
10
AUTO
AUTO Light Lit while the drive is in AUTO mode.
11
HAND
HAND Light Lit while the drive is in HAND mode.
12 ALM LED Light Lit or flashing when the drive detects an alarm or error.
13 REV LED Light Lit when motor is rotating in reverse.
14 DRV LED Light Lit when in Drive Mode or Auto-Tuning.
15 FOUT LED Light Lit then displaying output frequency.
i.6 Start-Up Programming and Operation
58 YASKAWA TOEP YAIQPM 02B YASKAWA AC Drive - iQpump Micro Quick Start Guide