Yaskawa YTerm - Manual (Page 36)

30
YTerm Software Manual
Storage Scope
The storage scope is used to store data. This allows the user to choose the
parameters observed and duration. The storage scope has the capability to
store up to four parameters (dependent on the type of graph selected).
To run the Storage Scope:
1. Click on Scope on the Tuning Screen to display the screen
shown below:
Figure 22: Storage Scope Parameters Screen
2. Determine and select Sample Time (in milliseconds) so the
Controller will sample the selected data at the appropriate
intervals.
3. Determine number of points to sample and display on the
graph.
4. The time frame in which the controller samples the data is a
function of: Sample Time x Points to Graph. This number is
displayed in Scope Time frame box on the Storage Scope
Graph.
5. Enter an optional command to be executed before starting to
store the data. Example: Enter the command XQ to execute
the program on the controller.