Yaskawa Ladder Works Programming Manual - Manual (Page 72)

4.4 OUTPUT STRAIGHT Instruction (OUTS)
4-7
4.4 DIRECT OUTPUT STRING Instruction (OUTS)
[Outline]
The OUTS instruction continuously performs direct output to a single module according to the
contents of a previously-set parameter table. OUTS can only be used for LIO modules.
[Format]
Symbol : OUTS
Full Name : Direct Output String
Category : CONTROL
Icon :
[Parameter]
Parameter Name Setting
Parameter · Register address (except for # and C registers)
· Register address with subscript
[Status] · Any bit type register (except for # and C registers)
· Any bit type register with subscript
* possible to omit
OUTS Instruction Parameter/Data
ADR Type Symbol Name Specifications Input or
Output
0 W RSSEL Module designation 1 IN
1 W MDSEL Module designation 2
Designation of module for performing
output*
IN
2 W STS Status Output of a bit equivalence of the status
for each word output OUT
3 W N Number of words Designation of number of words output
continuously IN
4 W OD1 output data 1 IN
･･･ ･･･ ･･･ ･･･ ･･･
N+3 W ODN output data N
Setting output data
IN
＊ Method of setting RSSEL and N (number of words) is the same as for INS.