Yaskawa Ladder Works Programming Manual - Manual (Page 16)

1.10 SET COIL Instructions (S-COIL)
1-11
1.10 SET COIL Instruction (S-COIL)
[Outline]
The S-COIL turns ON the output when the execution condition is satisfied, and maintains the ON state.
[Format]
Symbol : S-Coil
Full Name : Set Coil
Category : RELAY
Icon :
[Parameter]
Parameter Name Setting
Coil No. · Any bit type register (except for # and C register)
· Any bit type register with subscript (except for # and C registers)
[Program Example]
Case where the same output destination is designated multiple times.
The above example acts as in the graph below.
* When OB00000 is OFF,
with the "set coil"
instruction, OB00000
turns ON.
*
MB000000
MB000001
MB000002
MB000003
OB00000