Yaskawa CACR-SRxxBF - Manual (Page 41)

4 Settings and Display
4.1.4 Alarm Reset Button
4-4
4.1.4 Alarm Reset Button
When a SERVOPACK alarm occurs, eliminate the cause and then press the RESET Button to reset the servo
alarm.
If the cause has not been eliminated, the alarm will occur again.
4.1.5 LED Display
There are four LEDs on the board as follows.
4.1.6 Monitoring Pins
The monitoring pins listed in the table below are provided for monitor signals.
The levels are the same as the conventional models.
4.1.7 Digital Operator Connector
When using the re-engineered SERVOPACK as the replacement of the conventional model CACR-SR††BE or
CACR-SR††BY, the connector CN3 is used to connect the digital operator JUSP-OP05A.
RESET Alarm reset button
DS1 7-Segment LED SERVOPACK status and alarm display
LED lamp (1) Main circuit CHARGE LED Main circuit with high-voltage
LED lamp (2) Encoder conversion function Lit in yellow during normal operation
LED lamp (3) Encoder conversion alarm Lit in red at alarm occurrence
TMON For torque monitor
VTG For speed monitor
GND GND for monitor signal line
CN3
Connector for Σ-III series
digital operator
Cable connector