SMA SB 3600SE-10 Service Manual - Manual (Page 9)

7. Grip behind the left-hand side of the protective
cover and lever it loose. Then lift the protective
cover forwards and off.
8. Hold the Battery Pack by the side handles, and
slide it to the left of the wall mounting plate up to
the stop. This deactivates the lift-off protection of
the Battery Pack and gives you more room to
pull out the cables.
9. Remove the data cable from the Battery Pack.
Press the lateral brackets in and pull the plug out
of the pin connector.
10. Remove the power cable from the Battery Pack.
Turn the mating plug to the left until it releases
and pull it out of the pin connector.
11. If the protective caps of the pin connectors for the data cable and the power cable are
available, use them to cover the corresponding pin connectors of the Battery Pack.
12. Insert the data cable and power cable into the bracket on the left-hand side of the inverter.
2 Safety SMA Solar Technology AG
Service Manual 9 SB36-50SE-SG-en-10