SMA SB 3600SE-10 Service Manual - Manual (Page 7)

Danger to life due to high voltages on the Battery Pack
Lethal voltage is present at the pin connector for the power cable. Reaching into the pin
connector for the power cable can result in lethal electric shock.
• Do not open the Battery Pack.
• Do not wipe over the Battery Pack with a damp cloth.
• Leave the protective caps on the pin connectors for the power cable and the data cable until
the inverter cables are connected to the Battery Pack.
• Only operate the Battery Pack with its protective cover. The protective cover is separately
packed.
• Prior to performing any work on the inverter or the Battery Pack, disconnect the inverter from
all voltage sources as described in this document (see Section 2.3, page 8).
Danger to life due to electric shock
Touching an ungrounded PV module or an array frame can cause a fatal electric shock.
• Connect and ground the PV modules, array frame and electrically conductive surfaces so
that there is continuous conduction. Observe the applicable local regulations.
Risk of chemical burns from electrolyte or toxic gases
During normal operation, no electrolyte can leak from the Battery Pack and no toxic gases can
form. Despite careful construction, if the Battery Pack is damaged or a fault occurs, it is possible
that electrolyte may be leaked or toxic gases formed.
• Store the Battery Pack in a cool and dry place.
• Do not drop the Battery Pack or damage it with sharp objects.
• Only set the Battery Pack down on its back, i.e., on the side with the mounting lugs.
• Do not open the Battery Pack.
• Only operate the Battery Pack at ambient temperatures between 0°C and +40°C.
• Do not install or operate the Battery Pack in potentially explosive atmospheres or areas of
high humidity.
• If moisture has penetrated the Battery Pack (e.g. due to a damaged enclosure), do not install
or operate the Battery Pack.
• In case of contact with electrolyte, rinse the affected areas immediately with water and
consult a doctor without delay.
2 Safety SMA Solar Technology AG
Service Manual 7 SB36-50SE-SG-en-10