HEIDENHAIN TNC 620 (73498x-02) - Manual (Page 522)

MOD functions
17.1 MOD function
17
522
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
17.1 MOD function
The MOD functions provide additional input possibilities and
displays. In addition you can enter code numbers to enable access
to protected areas.
Selecting MOD functions
Open the pop-up window with the MOD functions:
To select the MOD functions, press the MOD key.
The TNC opens a pop-up window displaying the
available MOD functions.
Changing the settings
As well as with the mouse, navigation with the keyboard is also
possible in the MOD functions:
Switch from the input area in the right window to the MOD
function selections in the left window with the tab key
Select MOD function
Switch to the input field with the tab key or ENT key
Enter value according to function and confirm with OK or make
selection and confirm with Apply
If more than one possibility is available for a particular
setting, you can superimpose a window listing all
of the given possibilities by pressing the GOTO key.
Select the setting with the ENT key. If you don't want
to change the setting, close the window again with
END.
Exiting MOD functions
Exit MOD functions: press the ABORT soft key or END key