HEIDENHAIN TNC 620 (73498x-02) - Manual (Page 458)

Manual operation and setup
14.6 Using 3-D touch probes (Touch Probe Function software option)
14
458
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
14.6 Using 3-D touch probes (Touch Probe
Function software option)
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Function Soft key Page
Calibrating the effective length 466
Calibrating the effective radius 467
Measuring a basic rotation using a
line 471
Setting a datum in any axis 473
Setting a corner as datum 474
Setting a circle center as datum 476
Setting the centerline as datum 478
Touch probe system data
management See User’s
Manual for
Cycles
For more information about the touch probe table,
refer to the User’s Manual for Cycle Programming.