HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 83)

HEIDENHAIN TNC 620 83
3.2 Cr
eating and W
riting Pr
ogr
a
ms
Actual position capture
The TNC enables you to transfer the current tool position into the
program, for example during
„ Positioning-block programming
„ Cycle programming
To transfer the correct position values, proceed as follows:
U Place the input box at the position in the block where you want to
insert a position value.
U Select the actual-position-capture function. In the
soft-key row the TNC displays the axes whose
positions can be transferred.
U Select the axis. The TNC writes the current position of
the selected axis into the active input box.
In the working plane the TNC always captures the
coordinates of the tool center, even though tool radius
compensation is active.
In the tool axis the TNC always captures the coordinates
of the tool tip and thus always takes the active tool length
compensation into account.
The TNC keeps the soft-key row for axis selection active
until you deactivate it by pressing the
actual-position-capture key again. This behavior remains in
effect even if you save the current block and open a new
one with a path function key. If you select a block element
in which you must choose an input alternative via soft key
(e.g. for radius compensation), then the TNC also closes
the soft-key row for axis selection.
The actual-position-capture function is not allowed if the
tilted working plane function is active.