HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 111)

HEIDENHAIN TNC 620 111
4.2 A
dding Comments
4.2 Adding Comments
Function
You can add comments to a part program to explain program steps or
make general notes.
Entering a comment in a separate block
U Select the block after which the comment is to be inserted.
U Press the SPEC FCT key to select the special functions.
U To select the program functions, press the PROGRAM FUNCTIONS
soft key.
U Shift soft-key row to the left
U Press the INSERT COMMENT soft key.
U Enter your comment using the screen keyboard (see “Screen
keyboard” on page 110) and conclude the block by pressing the
END key.
Enter the file name using the screen keyboard (see
“Screen keyboard” on page 110).
If the TNC cannot show the entire comment on the
screen, the >> sign is displayed.
The last character in a comment block must not have any
tilde (~).
If you have connected a PC keyboard to the USB
interface, you can insert a comment block by simply
pressing the ; key on the PC keyboard.