HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 395)

HEIDENHAIN TNC 620 395
15.5 Ether
n
et Int
e
rf
ace
NFS option rsize: Packet size in bytes for data reception
wsize: Packet size for data transmission in
bytes
time0=: Time in tenths of a second, after which
the control repeats an unanswered Remote
Procedure Call.
soft: If YES is entered, the Remote Procedure
Call is repeated until the NFS server answers. If
NO
is entered, it is not repeated
SMB option Options that concern the SMB file system type:
Options are given without space characters,
separated only by commas. Pay attention to
capitalization.
Options:
ip: IP address of the Windows PC to which the
control is to be connected.
username: User name with which the control
should log in.
workgroup: Workgroup under which the control
should log in.
password: Password with which the control is
to log on (up to 80 characters)
Further SMB options: Input of further options
for the Windows network
Automatic
connection Automount (YES or NO): Here you specify
whether the network will be automatically
mounted when the control starts up. Devices
not automatically mounted can be mounted
anytime later in the program management.
You do not need to indicate the protocol with the TNC 620.
It uses the communications protocol according to RFC
894.
Setting Meaning