Corner as datum, 8 d a tum set ting with 3-d t o uc h pr obe – HEIDENHAIN TNC 620 (340 56x-02) ISO programming User Manual
Page 340
340
Manual Operation and Setup
12.8 D
a
tum Set
ting with 3-D T
o
uc
h Pr
obe
Corner as datum
U
Select the probe function by pressing the PROBING P
soft key
U
Position the touch probe near the first touch point on
the first workpiece edge.
U
Select the probe direction by soft key.
U
To probe the workpiece, press the machine START
button
U
Position the touch probe near the second touch point
on the same workpiece edge.
U
To probe the workpiece, press the machine START
button
U
Position the touch probe near the first touch point on
the second workpiece edge.
U
Select the probe direction by soft key.
U
To probe the workpiece, press the machine START
button
U
Position the touch probe near the second touch point
on the same workpiece edge.
U
To probe the workpiece, press the machine START
button
U
Datum:
Enter both datum coordinates into the menu
window, and confirm your entry with the SET
DATUM soft key, or see "Writing the measured
values from touch probe cycles in the preset table",
page 333.
U
To terminate the probe function, press the END soft
key.
P
X=?
Y=?
X
Y
P
X
Y