HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 452)

452
Compar
ison: F
unctions of the TNC 620 and the iTNC
530
Comparison: Differences in Manual Operation,
operation
Handling of preset table:
„ Editing the preset table in the
Programming mode of operation
„ Preset tables that depend on the
range of traverse
„ Entry of comment in DOC column
„ Possible
„ Not available
„ Via online keyboard
„ Not possible
„ Available
„ Via ASCII keyboard
Definition of feed-rate limitation Feed-rate limitation can be defined
separately for linear and rotary axes Only one feed-rate limitation can be
defined for linear and rotary axes
Function TNC 620 iTNC 530
Function TNC 620 iTNC 530
Character set for POSITION screen
layout Small position display Large position display
Capturing the position values from
mechanical probes Actual-position capture by soft key Actual-position capture by hard key
Exiting the touch probe functions menu Only via the END soft key Via the END soft key or the END hard
key
Exiting the preset table Only via the BACK/END soft keys Via the END hard key at any time
Multiple editing of tool table TOOL.T, or
pocket table tool_p.tch Soft-key row that was last active before
exiting is active Permanently defined soft-key row
(soft-key row 1) is displayed