HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 207)

HEIDENHAIN TNC 620 207
8.6 Chec
king and Changing Q
P
ar
amet
ers
8.6 Checking and Changing
Q Parameters
Procedure
You can check Q parameters when writing, testing and running
programs in all operating modes and, except in the test run, edit them.
U If you are in a program run, interrupt it if required (for example, by
pressing the machine STOP button and the INTERNAL STOP soft
key). If you are in a test run, interrupt it
U To call Q parameter functions: Press the Q INFO soft
key in the Programming and Editing mode of
operation.
U The TNC opens a pop-up window in which you can
enter the desired range for display of the
Q-parameters or string parameters
U In the Program Run Single Block, Program Run Full
Sequence and Test Run modes of operation, select
the screen layout Program + Status
U Select the STATUS OF Q PARAM. soft key
U Select the Q PARAMETER LIST soft key
U The TNC opens a pop-up window in which you can
enter the desired range for display of the
Q-parameters or string parameters
U With the Q PARAMETER REQUEST soft key (available
only in Manual Operation, Program Run Full
Sequence and Program Run Single Block), you can
request individual Q parameters. To assign a new
value, overwrite the displayed value and confirm with
OK.