HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 220)

220 Programming: Q Parameters
8.7 A
d
ditional F
unctions
Reference point from touch probe
cycle, 360 1 1 to 9
(X, Y, Z, A, B, C, U, V,
W) Last reference point of a manual touch probe cycle, or
last touch point from Cycle 0 without probe length
compensation but with probe radius compensation
(workpiece coordinate system)
2 1 to 9
(X, Y, Z, A, B, C, U, V,
W) Last reference point of a manual touch probe cycle, or
last touch point from Cycle 0 without stylus length or
stylus radius compensation (machine coordinate
system)
3 1 to 9
(X, Y, Z, A, B, C, U, V,
W) Result of measurement of the touch probe cycles 0
and 1 without probe radius or probe length
compensation
4 1 to 9
(X, Y, Z, A, B, C, U, V,
W) Last reference point of a manual touch probe cycle, or
last touch point from Cycle 0 without stylus length or
stylus radius compensation (workpiece coordinate
system)
10 - Oriented spindle stop
Value from the active datum table
in the active coordinate system,
500 Line Column Read values
Read data of the current tool, 950 1 - Tool length L
2 - Tool radius R
3 - Tool radius R2
4 - Oversize in tool length DL
5 - Oversize in tool radius DR
6 - Oversize for tool radius DR2
7 - Tool locked TL
0 = not locked, 1 = locked
8 - Number of replacement tool RT
9 - Maximum tool age TIME1
10 - Maximum tool age TIME2
11 - Current tool age CUR. TIME
12 - PLC status
13 - Maximum tooth length LCUTS
14 - Maximum plunge angle ANGLE
15 - TT: Number of teeth CUT
16 - TT: Wear tolerance in length LTOL
Group name, ID number Number Index Meaning