HEIDENHAIN TNC 620 (340 56x-02) ISO programming - Manual (Page 330)

330 Manual Operation and Setup
12.5 Using 3-D T
ouc
h Pr
obes
12.5 Using 3-D Touch Probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Function Soft key Page
Calibrate the effective length Page 334
Calibrate the effective radius Page 335
Measure a basic rotation using a line Page 337
Set the datum in any axis Page 339
Set a corner as datum Page 340
Set a circle center as datum Page 341
Touch probe system data
management See User’s
Manual for
Cycles
When running touch probe cycles, no cycles must be
active for coordinate transformation (Cycle 7 DATUM,
Cycle 8 MIRROR IMAGE, Cycle 10 ROTATION, Cycles 11
and 26 SCALING and Cycle 19 WORKING PLANE).
For more information about the touch probe table, refer to
the User’s Manual for Cycle Programming.