HEIDENHAIN iTNC 530 (340 49x-05) ISO programming - Manual (Page 568)

568 Tables and Overviews
1
8
.1 Gener
a
l User P
a
ra
met
e
rs
Error message during cycle call MP7441
Display error message if M3/M4 not active: Bit 0 = 0
Suppress error message if M3/M4 not active: Bit 0 = 1
reserved: Bit 1
Suppress error message if positive depth programmed: Bit 2 = 0
Display error message if positive depth programmed: Bit 2 = 1
M function for spindle orientation in the
fixed cycles MP7442
Function inactive: 0
Orientation directly through the NC: -1
M function for orienting the spindle: 1 to 999
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements MP7471
0 to 99 999 [mm/min]
Compatibility machine parameters for
datum tables MP7475
Datum shifts are referenced to the workpiece datum: 0
If the value 1 was entered in older TNC controls or in controls with
software 340 420-xx, datum shifts were referenced to the machine datum.
This function is no longer available. You must now use the preset table
instead of datum tables referenced to REF (see “Datum management with
the preset table” on page 444).
Time to be added when calculating the tool
usage time MP7485
0 to 100 [%]
Machining and program run