HEIDENHAIN iTNC 530 (340 49x-05) ISO programming - Manual (Page 38)

38
12.1 Functions for Multiple Axis Machining ..... 374
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 375
Introduction ..... 375
Define the PLANE function ..... 377
Position display ..... 377
Reset the PLANE function ..... 378
Defining the machining plane with space angles: PLANE SPATIAL ..... 379
Defining the machining plane with projection angles: PROJECTED PLANE ..... 381
Defining the machining plane with Euler angles: EULER PLANE ..... 383
Defining the machining plane with two vectors: VECTOR PLANE ..... 385
Defining the machining plane via three points: POINTS PLANE ..... 387
Defining the machining plane with a single, incremental space angle: PLANE RELATIVE ..... 389
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 390
Specifying the positioning behavior of the PLANE function ..... 392
12.3 Inclined-Tool Machining in the Tilted Plane ..... 396
Function ..... 396
Inclined-tool machining via incremental traverse of a rotary axis ..... 396
12.4 Miscellaneous Functions for Rotary Axes ..... 397
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 397
Shorter-path traverse of rotary axes: M126 ..... 398
Reducing display of a rotary axis to a value less than 360°: M94 ..... 399
Automatic compensation of machine geometry when working with tilted axes: M114 (software option 2) ..... 400
Maintaining the position of the tool tip when positioning with tilted axes (TCPM): M128 (software option
2) ..... 401
Exact stop at corners with nontangential transitions: M134 ..... 404
Selecting tilting axes: M138 ..... 404
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 405
12.5 Peripheral milling: 3-D radius compensation with workpiece orientation ..... 406
Function ..... 406
12 Programming: Multiple Axis Machining ..... 373