HEIDENHAIN iTNC 530 (340 49x-05) ISO programming - Manual (Page 501)

HEIDENHAIN iTNC 530 501
16.4 Pr
ogr
am Run
Running a part program
Preparation
1 Clamp the workpiece to the machine table.
2 Set the datum.
3 Select the necessary tables and pallet files (status M).
4 Select the part program (status M)
Program Run, Full Sequence
U Start the part program with the machine START button
Program Run, Single Block
U Start each block of the part program individually with the machine
START button
You can adjust the feed rate and spindle speed with the
override knobs.
It is possible to reduce the rapid traverse speed when
starting the NC program using the FMAX soft key. The
reduction applies to all rapid traverse and feed rate
movements. The value you enter is no longer in effect
after the machine has been turned off and on again. In
order to re-establish the respectively defined maximum
feed rate after switch-on, you need to re-enter the
corresponding value.