HEIDENHAIN iTNC 530 (340 49x-05) ISO programming - Manual (Page 312)

312 Programming: Miscellaneous Functions
1
0
.4 Miscellaneous F
unctions f
o
r Cont
our
ing Beha
vior
Restrictions
„ After an external or internal stop, you can only re-enter the contour
with the function RESTORE POS. AT N. Before you start the block
scan, you must cancel M120, otherwise the TNC will output an error
message.
„ When using the path functions G25 and G24 the blocks before and
after G25 or G24 must contain only coordinates in the working plane
„ Before using the functions listed below, you have to cancel M120
and the radius compensation:
„ Cycle G60 Tolerance
„ Cycle G80 Working plane
„ PLANE function
„ M114
„ M128
„ M138
„ M144
„ TCPM FUNCTION (only conversational)
„ WRITE TO KINEMATIC (only conversational format)