Intended place of operation, Legal information, Tnc model, sof tw a re and f eat ur es – HEIDENHAIN iTNC 530 (340 49x-05) ISO programming User Manual
Page 10
10
TNC Model, Sof
tw
a
re
and F
eat
ur
es
Intended place of operation
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Legal information
This product uses open source software. Further information is
available on the control under
U
Programming and Editing operating mode
U
MOD function
U
LEGAL INFORMATION soft key
FCL 2 functions
Description
3-D line graphics
Virtual tool axis
USB support of block devices (memory
sticks, hard disks, CD-ROM drives)
Possibility of assigning different depths
to each subcontour in the contour
formula
User’s Manual for
Cycles
DHCP dynamic IP-address management Page 532
Touch-probe cycle for global setting of
touch-probe parameters
User’s Manual for Touch
Probe Cycles
smarT.NC: Graphic support of block scan smarT.NC Pilot
smarT.NC: Coordinate transformation
smarT.NC Pilot
smarT.NC: PLANE function
smarT.NC Pilot