HEIDENHAIN iTNC 530 (340 49x-05) ISO programming - Manual (Page 437)

HEIDENHAIN iTNC 530 437
14.2 Mo
ving the Mac
h
ine Ax
es
Moving the axes
Activate the handwheel: Press the handwheel key on
the HR 420. Now the TNC can be operated only
through the HR 420. A pop-up window with a text to
this effect appears on the TNC screen.
Select the desired operating mode via the OPM soft key, if necessary
(see “Changing the modes of operation” on page 439)
If required, press and hold the permissive button
Use the handwheel to select the axis to be moved.
Select the additional axes via soft key
Move the active axis in the positive direction, or
Move the active axis in the negative direction
Deactivate the handwheel: Press the handwheel key
on the HR 420. The TNC can now again be operated
from the control panel
Potentiometer settings
The potentiometers of the machine operating panel continue to be
active after you have activated the handwheel. If you want to use the
potentiometers on the handwheel, proceed as follows:
U Press the CTRL and Handwheel keys in the HR 420. The TNC shows
the soft-key menu for selecting the potentiometers on the
handwheel display
U Press the HW soft key to activate the handwheel potentiometers
If you have activated the potentiometers on the handwheel, you must
reactivate the potentiometers of the machine operating panel before
deselecting the handwheel. Proceed as follows:
U Press the CTRL and Handwheel keys in the HR 420. The TNC shows
the soft-key menu for selecting the potentiometers on the
handwheel display
U Press the KBD soft key to activate the potentiometers of the
machine operating panel