HEIDENHAIN CNC Pilot 4290 Description of the Y axis - Manual (Page 45)

HEIDENHAIN CNC PILOT 4290 45
4.1.1 Definition of Reference Data
In the ”reference data” dialog box you define the
position of the front face, rear side, or lateral surface
contour.
Y front face/Y rear side
C: Spindle angle (spindle position) – default: 0
Limit diameter: serves to limit the cutting area if the
figure lies partly outside the workpiece
Z: Reference dimension (position of the
reference plane)
4.1.1
Definition
of
Reference
Data
Parameters Y lateral surface
C: Spindle angle (spindle position) – default: 0
Z: Limit dimension – reference position for sin-
gle surfaces and centric polygons
Reference diameter:
■ Reference position for the figures/
contours.
■ Serves to limit the cutting area if the
figure lies partly outside the workpiece.
Y_4290BH.pm6 08.03.2005, 08:36 45