HEIDENHAIN CNC Pilot 4290 Description of the Y axis - Manual (Page 34)

Y Axis 34
2.4.1
Milling
with
the
Y
Axis
2.4 Examples
2.4.1 Milling with the Y Axis
%bsp_y.nc
. . .
REVOLVER 1 [TURRET]
T2 ID”111-35-08-Y”
T5 ID”511-17.0-Y”
T7 ID”511-6.0-Y”
T9 ID”512-15.7-Y”
T11 ID”512-6.0-Y”
ROHTEIL [BLANK]
N1 G20 X100 Z220 K1
FERTIGTEIL [FINISHED PART]
N2 G0 X0 Z-120
N3 G1 Z0
N4 G1 X50 B-2
N5 G1 Z-40 B3
N6 G1 X80 B-2
N7 G1 Z-100
N8 G1 X100 B-2
N9 G1 Z-120
N10 G1 X0
STIRN_Y Z0 X50 C0 [FRONT_Y]
N11 G477 K40 B-3 Q6
STIRN_Y Z0 X46 C0 [FRONT_Y]
N12 G308 P-2
N13 G377 X4 Y0 Q6 A30 K17.3205 R3
N14 G309
MANTEL_Y X50 C180 [SURFACE_Y]
N15 G308 P-3
N16 G381 Z-12 Y0 A0 K30 B8
N17 G309
MANTEL_Y X80 C90 [SURFACE_Y]
N18 G308
N19 G386 Z-37 Ki15 B-43
N20 G308 P-2
N21 G180 Z-53 Y0
N22 G181 Y? B12 Q1
N23 G183 Z-61 Yi0 R12 K-57 J-18 B12
N24 G181 Y? A-90 B12
Program name
Program header
Tool for turning
Radial drilling and slot milling tool
Radial drilling and slot milling tool
Axial drilling and slot milling tool
Axial drilling and slot milling tool
Definition of the turning contour
Position of milling contour on the face
Centric polygon (for axial machining)
Depth of the following figure: 2 mm
Eccentric polygon on the face
Contour position on lateral surface (spindle angle 180°)
Depth of the following figure: 3 mm
Linear slot on the lateral surface
Contour on the lateral surface
Single surface (for radial machining)
The following contour is milled in the single surface (depth: 2 mm)
Starting point ”free contour”
Y_4290BH.pm6 08.03.2005, 08:36 34