HEIDENHAIN ND 231 B v.2 User Manual
Page 3
3
Key
Function
Datum setting
Confirming the entry value
Setting display to value from P79 (P80!)
Exiting the parameter list
Datum selection
Paging backward in the parameter list
Outputting the meas. value with PRINT
Selecting parameters after switch-on
Paging forward in the parameter list
Clearing the entry
Resetting the display to zero (P80!)
CL plus MOD: Parameter list
CL plus number: Selecting a parameter
Clear parameter entry and show
parameter number
Algebraic sign
Decreasing the parameter value
Decimal point
Increasing the parameter value
MOD
Indicator
Meaning
REF
If the decimal point is blinking:
Display is waiting for the reference mark
to be traversed.
If the decimal point is not blinking:
Reference mark was traversed—
display unit saves the datum in nonvolatile
memory
Blinking: Display is waiting for operator
to press ENT or CL
inch
Position values in inches
1 / 2
Selected datum
Measured value output with the MOD key
SET
Blinking: Display is waiting for entry values
< / = / >
Sorting mode: Measured value less than
lower limit / within tolerances / greater
than upper limit.
MIN / MAX /
Nonfunctional
DIFF / ACTL /
START