2 card installation, 3 rear panels and connectors, 1 images of rear connector panels – Grass Valley SME-1901 v.1.20 User Manual
Page 9: Card installation, Rear panels and connectors, Images of rear connector panels
GUIDE TO INSTALLATION AND OPERATION
SME-1901 / 1911 | 5
To install the connector panel (Densité 2 and Densité 3 frames):
1. If a card is installed in the slot whose rear panel is being changed, remove it as described above.
2. Remove the existing panel (either blank or belonging to an existing card that is being changed) by releasing the
captive screw(s) at the bottom.
3. Position the new panel and secure it in place with the captive screw(s) at the bottom.
2.2 Card Installation
Once a matching rear connector panel has been installed, install the SME-1901/1911 card as follows:
1. Open the front panel of the frame.
2. Slide the SME-1901/1911 card into the slot and push gently on the handle to seat the connectors.
• For the double-slot-width rear panels used in Densité 2 frames, insert the card into the right-most slot, as
seen from the front of the frame. If the card is inserted into the wrong slot, the status LED on the front of the
card will flash red. The card will not be damaged.
3. Close the front panel of the frame.
2.3 Rear Panels and Connectors
2.3.1 Images of rear connector panels
The available rear panels for the SME-1901 and the SME-1911 are shown in the figures below, and their various
inputs and outputs are described.
Figure 2.1 SME-1901 Rear Panels