Grass Valley SME-1901 v.1.20 User Manual
Page 22
GUIDE TO INSTALLATION AND OPERATION
18 | SME-1901 / 1911
• Unicast TS-over-UDP/RTP (raw TS carried over UDP from a single source to a single destination)
• Multicast TS-over-UDP/RTP (raw TS carried over UDP from a single source to multiple destinations)
• RTSP/TS-over-UDP/RTP (RTSP’s packetization of TS and carried over UDP)
• RTSP/TS-over-TCP (RTSP’s packetization of TS and encapsulated into an RTP-TCP connection)
The Main and Proxy streams each have the following parameters:
On/Off – use the pulldown to enable or disable the stream
IP address – enter the IP address of the destination. It is relevant for all connection types except RTPS/TS-over-
UDP/RTP and RTSP/TS-over-TCP.
Port – enter the port number; valid port numbers are in the range 1024 to 65535.
After changing any of these parameters, you must click Apply for the changes to take effect, or Cancel to discard the
changes.
The decoder or set-top box will require a URL. It will have a different form depending on the chosen Streaming
Protocol. The following description gives examples for the VideoLAN VLC Media Player software. Please refer to your
decoder or set-top box documentation.
Unicast TS-over-UDP and TS-over-UDP/RTP
The
destination is the Main or Proxy IP Address and Port from the Streaming Panel.
udp://@10.1.1.100:10000
rtp://@10.1.1.100:10002
Multicast TS-over-UDP and TS-over-UDP/RTP
The
the card’s IP Address from the Network Settings panel. This will depend on the IGMP configuration in the network
equipment (switch or router). The
Streaming Panel.
• No IGMP
udp://@239.1.1.100:10000
rtp://@239.1.1.100:10002
• IGMP Any Source Multicast (ASM)
udp://[email protected]:10000
rtp://[email protected]:10002
• IGMP Specify Source Multicast (SSM)
udp://[email protected]:10000
rtp://[email protected]:10002
RTSP/TS-over-UDP/RTP and RTSP/TS-over-TCP
Main stream: rtsp://