Grass Valley PDR 200 Installation - Manual (Page 74)

Chapter 3 Starting Your Profile System
3-8 Profile Video File Server Installation
• Check the status of the rear panel LEDs three to four minutes after power On.
Compare with the status listed in Table 3-1. Not all of the boards listed may be
installed in your Profile system. Refer to Tables 1-2 through 1-5 in Chapter 1 pages
1-9 through 1-12, for the standard location of these boards.
Table 3-1. Rear Panel Board Indicators
If all LEDs are as indicated in Table 3-1, run the diagnostics below. If board LEDs
are not as indicated, contact your Grass Valley Group representative.
Board Status/Description
AUDIO I/O
Digital AES/EBU
Red LED should be off. (On at power up and then off after a few minutes.)
VIDEO IN
Analog Component
Red LED should be off. (On at power up and then Off after a few minutes.)
VIDEO OUT
Analog Composite
Red LED should be off. (On at power up and then off after a few minutes.)
FIBRE CHANNEL Red LED should be on.
DISK RECORDER
Master/Slave
Red LED(s) should be off. (On at power up and then off after a few minutes.)
MPEG
Encoder/Decoder
Red LED(s) should be off. (On at power up and then off after a few minutes.)
MPEG
Decoder
Red LED(s) should be off. (On at power up and then off after a few minutes.)
DVCPRO Codec Red LED should be off. (On at power up and then off after a few minutes.)
VIDEO I/O
Serial Digital
Component
Red LED should be off. (On at power up and then off after a few minutes.)
VIDEO I/O Analog
Composite
Red LED should be off. (On at power up and then off after a few minutes.)
REFERENCE
Analog Video Red LED should be off. (On at power up and then off after a few minutes.)