Grass Valley PDR 200 Installation - Manual (Page 37)

Making Rear Panel Connections
Profile Video File Server Installation 2-7
Making Rear Panel Connections
Because of the flexible configurations of the Profile Video File Server, not all of the
rear panel connections described here may apply to your Profile system. The
connections are described as though all factory installable options were in fact
installed. As you go through these instructions, simply ignore a board you do not have
installed. Note that any rear panel slot which does not have a board installed will have
a blank cover over the rear panel slot.
NOTE: Insure that power switches of all equipment to be installed are in the
Off (O) positions.
To insure compliance with EMI standards, all BNC cable connections require that an
EMI suppression gasket be attached as shown in Figure 2-6. Your Profile system
shipment included a set of gaskets.
Figure 2-6. BNC Connection With EMI Gasket
9040-1