Grass Valley PDR 200 Installation - Manual (Page 41)

Connecting Video
Profile Video File Server Installation 2-11
Connecting Analog Composite Video I/O
The Profile Video File Server may include one or more an Analog Composite Video
In/Output boards. Figure 2-11 shows analog composite video cable connections for a
typical location, slot J14. Refer to the rear panel labels or Tables 1-2 through 1-6 in
Chapter 1, pages 1-9 through 1-13, to determine the slot location of this board in your
system.
The Analog Composite I/O board accepts two composite analog video inputs, and
provides two composite analog video outputs. The board is also equipped with an
S-Video connector, which allows video input to the Profile system directly from a
source such as a video cassette recorder. However, the S-Video device takes the place
of one of the inputs (either In A or In B). The board provides time base correction for
any one input. If the Analog Composite Video I/O board is installed, refer to
Figure 2-11 for an example and:
1. Place an EMI gasket on the BNC connectors being used as shown in Figure 2-6,
page 2-7.
2. Connect analog composite input and output cables to the Analog Composite I/O
board. See Figure 2-11 for an example.
Figure 2-11. Analog Composite I/O Cable Connections
J1 J17 J13 J16 J15 J14 J6 J7 J4 J3 J2 J5 J12 J11 J9 J8 J10
9676-58
Video I/O
Analog Composite
S-video In
In B
Out A
Out B
In A