Grass Valley PDR 200 Installation - Manual (Page 36)

Chapter 2 Mechanical Installation
2-6 Profile Video File Server Installation
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and
allow the tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the chassis in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack
to complete the installation.
Mounting Panels and Audio Chassis
Refer to the information that follows when mounting panels and audio chassis:
• The RS-422 Connector Panel is 1 RU high with the mounting holes spaced 1.250
inches (3.175 cm) apart.
• The XLR 216 is 2 RUs high with holes spaced 3.000 inches (7.62 cm) apart.
• The BNC216 is 1 RU high with holes spaced 3.000 inches (7.62 cm) apart.
• The PAC208 and PAC 216 Audio Breakout panels are 2 RUs high with holes
spaced 3.000 inches (7.62 cm) apart.
The RS-422, XLR 216 and BNC216 panels mount at the back of the rack with four
pan head screws. Ensure that there is room to make cable connections and mount in
any order which allows connection to the PRO Series Video Disk Recorder.