Grass Valley PDR v.2.1 - Manual (Page 32)

Chapter 2 Using the Profile Configuration Manager
16 Profile Family
- Verify Automatic VITC detect is not selected. If it is, click to toggle it.
- Set VITC Reader Line1 and VITC Reader Line2 to the lines where VITC
is located. If you only have one VITC line, enter the same value on both
Reader lines.
- Check VITC Present. If it is still not on, double check your line numbers
and try again.
4. For each video output that should have VITC, select it from the list. The
procedure is different for each type of signal:
• For analog composite:
- Verify VITC Generator Enable is checked. If not, click to toggle it.
- Click on Vert. Interval to open the Vertical Interval Line Programming
dialog box.
- Select the desired VITC lines by checking in the VITC Enable column for
the line. There is not a limit on the number of VITC lines.
- Click Close to close the Vertical Interval Line Programming dialog box.
• For serial digital component:
- From the Serial Digital Component Video Output dialog box, set the lines
where you want VITC in VITC Generator Line1 and VITC Generator
Line2.
- Verify VITC Generator Enable is checked. If not, click to toggle it.