Grass Valley NV9608 v.1.0 - Manual (Page 64)

54 Rev 1.0 • 18 Aug 10
5. Operation
Setup Mode
Your panel may have many local salvos. When you are defining local salvos, the salvo pages that
appear include both system salvos and local salvos. You might need to scroll the pages to find a
blank salvo button or an existing local salvo that you want to overwrite.
If you are viewing a full salvo page and wish to return to the local salvos menu, press ‘Clear’
S It is advisable not to overwrite system salvos. The panel does not indicate which salvos are sys-
tem salvos.
Setup Mode
Setup mode occurs when the NV9616 is disconnected from its network and is freshly powered up.
In setup mode, you can set or change the panel ID, identify the software version, and perform a test
of the panel’s buttons. It is in setup mode that you must initially set the panel ID.
After a few seconds, the LCD buttons will show ‘Acquire IP Address’ on the seond button and the
panel’s current panel ID on the first button. The right-hand button is designated the menu button:
Press the menu button to proceed to the setup menu:
There are 3 submenus: panel ID entry, software versions, and panel test mode.
Press the menu button to proceed to the first part of setup which is to set the panel ID:
NV9616 NV9616
PANEL ID PANEL ID
0 0
ACQUIRE ACQUIRE
IP IP
ADDRESS ADDRESS
MENU MENU
PANEL PANEL
ID ENTRY ID ENTRY
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
PANEL PANEL
ID ENTRY ID ENTRY
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT