Grass Valley NV9608 v.1.0 - Manual (Page 22)

12 Rev 1.0 • 18 Aug 10
3. Installation
Installation
Installation
Follow these steps to install a NV9616 or NV9608 control panel:
1 Mount, and secure, the panel in the rack.
The NV9616 and NV9608 are designed to mount in a 19 ″ rack. Rack-mounting is not a require-
ment.
2 We assume that you have an Ethernet switch connected to the “Panel and Router Network” port
of your system controller. Connect an Ethernet cable from that switch to the RJ-45 port at the
rear of the panel.
3 Connect power.
Installing Software and Documentation
This document is available through the Miranda web site.
You must use NV9000-SE Utilities to configure the NV9616 or NV9608 control panel. Contact
Miranda if you need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your panel to have a static IP address
(with respect to the NV9000) or to use DHCP. The panel, as it comes from the factory, defaults to
DHCP.
Initialization
Before your NV9000 system controller can communicate with your panel, you must give it a panel
ID. Follow these steps for each NV9616 you are installing:
1 Power up the panel. Do not connect its Ethernet cable. (Disconnect it if it is connected.)
After a few seconds, the LCD buttons will show ‘Acquire IP Address’ on the seond button and
the panel’s current panel ID on the first button. The right-hand button is designated the menu
button:
2 Press the menu button. The menu appears:
The menu has three submenus. Press the ‘Panel ID Entry’ button.
NV9616 NV9616
PANEL ID PANEL ID
0 0
ACQUIRE ACQUIRE
IP IP
ADDRESS ADDRESS
MENU MENU
PANEL PANEL
ID ENTRY ID ENTRY
SOFTWARE SOFTWARE
VERSIONS VERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT