Grass Valley NV9601 v.2.2 - Manual (Page 64)

54
Operation
Menu Mode
Illumination
Press selection button 4, corresponding to ‘Illumination’ to view and change button brightness.
The illumination submenu appears:
Press selection button 1 to enable changes to the low-tally illumination level.
Press selection button 2 to enable changes to the high-tally illumination level.
Press the ‘Page Up’ or ‘Page Down’ buttons to change the illumination values in increments of
10%. The right-hand array of 20 buttons shows the illumination level for green and for amber.
The illumination levels are constrained so that high-tally is always brighter than low-tally. The
defaults are 40% for low-tally and 100% brightness for high-tally.
Press selection button 7 to cancel your entry and return to the main menu.
Press selection button 8 to save the new levels and return to the main menu.
Salvo
From the main menu, press selection button 5, corresponding to ‘Salvo’ to view the salvo
submenu:
The salvo submenu lets you create and delete local salvos. A local salvo is one that you create
by recording actions that you perform at your panel. After recording the salvo, you must name
and store the salvo.
 Configurers and operators note: local salvos cannot be stored in an NV915 permanently. If
the NV915 is ever restarted, you will not be able to retrieve locally defined salvos. The names
of the local salvos persist, however, but the salvos are “empty.” The NV920 and NV960 do not
have this limitation.
There are 5 commands in the salvo menu:
• Start Salvo Record.
• Pause Salvo Record.
• Save Salvo.
• Cancel Salvo Record.
• Clear Local Salvo.
Menu Use 40% Low 1
Illumination Arrows 100% High 2
Cancel 7
Save 8
Menu Start Salvo Record 1
Salvo Pause Salvo Record 2
Save Salvo 3
Cancel Salvo Record 4
Clear Local Salvo 5
Exit 8