Composite out web page – Grass Valley Kameleon HD Multi-Function Modules v.2.5.0 User Manual
Page 92
92
Kameleon HD—Instruction Manual
Initial Configuration Process Overview
Composite Out Web Page
The Composite Out web page (
for 525 line rate and
for 625 line rate) is present when the module has
down conversion capability (KAM-HDD-PA and KAM-HDD-FS with HD
59.94 or HD 50 video input or an SD video input).
The Composite Out web page provides the following controls for adjusting
the composite video output:
Output Video
Enable the following output components in the composite video output by
checking the
Enabled
checkbox:
•
Signal Setup
– (525 line rate only) enable or disable setup on the com-
posite output signal.
•
Burst
– enable or disable burst on the composite output signal.
•
Chrominance Signal
– enable or disable chrominance on the composite
output signal.
•
Output Video Adjustment
– select the
Calibrated
radio button to output
factory calibrated values or the
User Adjustable
radio button to enable the
Luma Gain, Chroma Gain, Black Level, and Hue (525 only) composite
output controls on the right side of the web page display inside the
dashed lines in
and described below. For factory
default values, refer to
.
•
Output Video Gain
– adjust the overall output gain of the composite video.
•
Delay Coarse
– adjust the coarse delay of the video output in half-pixel
increments.
Output Video Adjustment - User
When the User Adjustable radio button is selected, the following output
video controls become enabled:
•
Luma Gain
– adjust the percentage of luma gain relative to 100% on the
composite output signal.
•
Chroma Gain
– adjust the percentage of chroma gain relative to 100% on
the composite output signal.
•
Black Level
– adjust the percentage of black relative to 0 (zero) on the
composite output signal.
•
Hue
– (525 line rate only) adjust the hue in degrees on the composite
output signal as needed.
Use
this
link