Grass Valley Kameleon HD Multi-Function Modules v.2.5.0 - Manual (Page 14)

14 Kameleon HD—Instruction Manual
Installation
Figure 2. 2000T1DNG Frame, Rear View
2. Insert the rear module into the vacant rear slot of the frame as
illustrated in
Figure 3 .
3. Verify that the module connector seats properly against the midplane.
4. Using a crossblade screwdriver, tighten the two screw locks to secure
the module in the frame.
CAUTION Using the incorrect rear module can cause overheating of the Kameleon 2000
frame.
Figure 3. Installing Passive Rear Module
5. Locate the corresponding front media slot (1 -12) in the 3 RU frame
frame (
Figure 4 ) or front media (slot 1-4) the 1 RU frame ( Figure 5 ).
Place the KAM-HDD/-FS module in the lower slot when using a
dual-height rear module.
8341_11
r1
Media section
rear slots 1-2
(with VID-HDD-R Rear Module)
J101
1
2
3
4
J102
Media section
rear slots 3-4
Network
and reference
input connections
Power connections
CVO CVO FIBER IF SDO SDO SDO
SDO
J10 J9 J7 J6 J5 J4 J3 J1
V1
KAM VID
HDR
Alignment post
and receptacle Screw lock
(both sides)
8341_06
2000 frame (rear view)
Board edge guides
(both sides)