Initial configuration process overview – Grass Valley Kameleon HD Multi-Function Modules v.2.5.0 User Manual
Page 33
Kameleon HD—Instruction Manual
33
Initial Configuration Process Overview
Initial Configuration Process Overview
To configure the Kameleon module proceed as follows:
1.
Go to the I/O Config web page (find the applicable module
configuration starting on
) to name inputs and outputs.
2.
Go to the System Config web page (find the applicable module
configuration starting on
) to configure the input video type
(HD or SD), the video input rate, and the output timing source; and for
modules supporting down conversion, BNCs J3 and J4 as SD or HD
outputs. Split Screen controls are also available on this page as well as
on the HD Video Proc, SD Video Proc, and Color Correction web pages.
3.
If not already connected, connect all input and output signals and
verify component and signal presence and condition on the Status web
page (
).
4.
Go to the Functional View web
page (find the applicable module
configuration starting on
) to use the block links to configure
each function in turn. Video processing must be enabled on the System
Config web page or with the Newton control panel.
Note
Next, Functional View, and Back links are provided to help you navigate
through a logical configuration sequence.
5.
Use the Slot Config web page (
) to assign Slot Configuration
information such as slot name and asset number. Also link to the
2000NET module web pages to enable and disable Frame Health and
SNMP trap reporting.
6.
Use E-MEM memory (
) to store or recall configurations as
necessary.
7.
Software Updating is performed using the NetConfig Networking
application (
).